Defence

The high reliability and the perfect functioning of the equipment being utilized are crucial prerequisites in this industry. Preventive inspection and testing of these materials is highly recommended to ensure the capabilities, quality and reliablity of the system in question. Over many years various test specifications have been developed in support of these activities, with particular focus on the wide range of environments in which the equipment may be used, for example MIL-STD, ECSS, NASA, DEF STAN, STANAG, RTCA-DO, ITOP, etc.

Through our experience and knowledge of our staff and our partners, we are able to offer customers in this market area a wide range of testing solutions suitable for any method of the main standards, thus enabling our customers to be fully confident that the equipment they purchase to perform these crucial tests is supported by a supplier with an in-depth knowledge of industry specifications and test procedures.

Vibration test chamber

Through controlled, incisive testing, you can prevent potential premature failures and protect yourself from incurring unnecessary costs. STTAi is here to offer you the means to do physical stress tests on your automotive components and products.

With 4-Poster climatic chambers and configurable features, the chamber allows you to test for - and not limited to - climatic, NVH (Noise, vibration and harshness), vehicle durability and sun simulation tests. These sets of tests provide you the ability to closely replicate the environments and accelerate their effects on your products, so that any underlying flaws and faults are revealed and thus dealt with before launch.

Also, we can provide you the chassis dynamometer, which can be combined with the standard climatic chamber, allowing testing of the engine compartment’s efficiency under administered climatic stress. This simulates the stress experienced during typical cycles of a vehicle’s working life according to international automotive standards.

Sand/dust and rain test

During their effective lifespan, national defense equipment are subjected to more than just wear due to temperature and humidity, but also from atmospheric agents such as dust, sand and rain. However, such unpredictably damaging factors can still be tested for, pre-emptively addressing underlying complications, ensuring that the products you manufacture will not wear out prematurely.

Our test chambers comply with all major international standards, such as reproducing all the conditions included in the standards requiring continuous ventilation (DIN 40046, MIL-STD 331 AND MIL-STD 810 C), dust drop tests (DIN 40052) and tests with irregular whiff of compressed air (SAE J 575). Furthermore, our chambers for rain tests are manufactured according to DIN specifications, so you can be sure that test results will be precise and reliable.